EKey Fingerscan Access Control System Instruções de Operação descarregar pdf (Página 22)

General

8.2.1.11

CHANGING THE RELAY SWITCHING TIMES

The switching impulse times of the individual relays can be variably adjusted from 1s to 99s. This enables

you to adjust the duration of the opening impulse of the door according to your application.

All the relays on your ekey home control panel are preset at

s impulse duration.

Special feature relay time 0

If the value 0 is assigned to a relay in this menu, then a special function is active. In this case the relay is

bi-stable. This means that when a finger is recognized, the relay changes to its switched state and

remains there until another finger is recognized. That relay thereby works as a switch and does not emit

an impulse.

If there is a power cut or a RESET on the ekey home FS or the ekey home CP due to a

trouble signal in this operating mode (relay permanently closed), then the relay always

restarts in idle state once the power supply has been reconnected (or after the reset).

Contact NO = open!!

If you operate for instance an alarm system via relay permanent status (relay time =

0), then a power cut could deactivate the alarm system! You can also provoke a reset by

swiping 10 times in a row an unknown finger over the finger scanner! Therefore keep in

mind that this feature has limitations!!

1.)

First enter the security code as per section 8.2.1.6

2.)

Press the > button until “rt” is displayed

3.)

Press the OK button

4.)

Only proceed with step 4 if you have an ekey home control panel with more than 1 relay:

ekey home CP IN 2

ekey home CP WM 3

Use the < and > buttons to select “o1”, “o2”, “o3” for the desired relay (NOT on ekey home CP

WM 1 and ekey home CP IN 1, as they only have one relay available!)

5.)

Press the OK button

6.)

Use the < and > buttons to set the desired duration of the switching impulse

0 = special feature „Switch“

1 = 1 sec

2 = 2 secs

99 = 99 secs

7.)

Press the OK button

8.)

“OK” will appear on the display for a short time. The device then returns to normal mode.

The duration of the impulse or the switching feature has therefore been set for the selected relay. Repeat

this procedure for each relay, the impulse duration of which you wish to change.

Relaisschaltzeit für das

gewählte Rela is ist

einge stellt!

ENTER SECURITY

CODE

DISPLA Y +

SETTING

KEY STROKE DISPLAY +

SETTING

KEY STROKE DISPLA Y +

SETTING

KEY STROKE DISPLA Y DISPLA Y

SEE B:

Select

MEN

ITEM rt

Select RELAY

Switching time in

secs (0; 1-99)

FINISHED

STA RT

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 40 41

Comentários a estes Manuais

Sem comentários

EKey Fingerscan Access Control System Instruções de Operação Página 22

Comentários a estes Manuais

Manuais e produtos relacionados com Câmaras de segurança EKey Fingerscan Access Control System